11) Forks on an empty truck should be carried about 10 cm off the ground and level. When carrying pallets, totes or bins, etc. that extend below the forks, maintain a distance of 10 cm between the floor surface and the bottom of the load, tilting the mast as necessary to stabilize the load.
When traveling with a load the lift forks should be how far off the floor?
6 to 10 inches
Keep the forks 6 to 10 inches above the ground to avoid potential hazards on the ground. Remember that forklifts are top-heavy. Carry the load low and tilted back. Use caution when carrying a load on an uneven surface; it creates a tip-over hazard.
Where should the forks or load be positioned while driving a loaded forklift?
drive with the fork arms as close to the ground as reasonably practicable, with the tips of the fork arms tilted slightly upwards and away from the ground, whether driving with or without a load.
When traveling with a load your forks should be no more than 6 inches off the floor?
Keep the forks 6 to 10 inches above the ground to avoid potential hazards on the ground. Remember that forklifts are top-heavy. Carry the load low and tilted back. Use caution when carrying a load on an uneven surface; it creates a tip-over hazard.
What direction should the lift be driven down a ramp when carrying a load?
When going down a ramp, drive in reverse with the load and keep the forks pointed up the slope. When traveling without a load, the forks should always point down the slope. The forklift operator should also drive in reverse up the ramp or drive forward when going down the ramp.
When picking up a load it should be tilted?
The mast must be carefully tilted backward to stabilize the load.
- Ensure the load is secured before moving.
- Carefully tilt the mast backward to stabilize the load. [
- Slowly move the truck to 20 to 30 cm (8 to 12 inches) away from the stack.
- Stop the truck.
What 3 guards are fitted to a forklift?
One final passive safety feature is the overhead guard. In the unlikely event that part of the load falls off of a raised pallet, the overhead guard is designed to protect the operator from small objects. The overhead guard is constructed to a very high standard and is an integral part of the forklift’s design.
Where are the forks supposed to be in a forklift?
A properly trained operator will carry his forks or load 4-6 inches off the ground. This position is high enough to reduce contact with dock plates, expansion joints in concrete, uneven areas, slight slopes, inclines and debris on operating surfaces. Moreover, when traveling with or without a load the forks should always be?
Do you tilt your fork back when carrying a load?
Per OSHA regulations, always tilt forks back when carrying a load. While different loads require unique angles, a slight tilt is all that is needed on most lift trucks to help retain loads when a fast stop is required. Unstable, round, liquid or loose stacked loads may require higher degrees of tilt back. Forks on the ground are a trip hazard.
Can a fork be left on the ground?
Forks on the ground are a trip hazard. However, if the forks are on the ground, you get an opportunity to lift your foot as you trip to recover balance. If a fork tip or heel is left up, a pedestrian stepping over can hook her foot underneath and fall. This is referred to as a “hook fall”.
What happens if a forklift is carried too high?
As an example, if a pedestrian steps out 6 feet in front of an operator with the forks or load carried too high, the pedestrian could be knocked down and dragged underneath the load against rotating tires for up to 10 feet of travel. The chance of survival is very slim. Per OSHA regulations, always tilt forks back when carrying a load.
