For a Kenmore brand dryer, the typical cost of the heating element can usually be found ranging from $20 to $43 whether it is available at a local store or buy online.
How old is my Kenmore 90 series dryer?
The 90 series range from late 80’s to 2000. Our system is showing a general manufacturer’s date of 1996. The date of manufacture is encoded in the serial number of the dryer.
Is it worth replacing a heating element in a dryer?
If your dryer’s heating element burns out more than once within a year or two, the thermal fuse, which is supposed to protect it, is probably defective, so it’s a good idea to replace it. The temperature in the heating chamber may also be too high, and that may be caused by poor venting.
Is Kenmore 90 series dryer gas or electric?
Another method for checking whether you have a gas or electric dryer is to pull the machine a few inches from the wall – just enough so that you can shine a flashlight behind it. If you see one cord attached to the dryer, it’s electric. If you see a cord and a thin stainless steel connector, your dryer is gas.
How can you tell if a dryer heating element is bad?
Inspect the metal wire coil for any breaks in the wire. If the wire is solid and has no breaks in it, the heating element should be good. If the wire has a break in it, the heating element is defective.
How long should a dryer heating element last?
between 8 and 18 years
The heating element can last between 8 and 18 years if the dryer is well-maintained and the vent and lint traps are clean. The heating element can burn out if the dryer is not kept well-maintained.
What causes a dryer element to burn out?
A dryer’s heating element operates on the same principle as the coil in an electric heater. It consists of an uninsulated metal conductor and when an electric current passes through it, its resistance to the flow of electricity makes it heat up. If the coil gets too hot, it burns out.
How can I tell what year my Kenmore dryer was made?
The second letter of the serial number identifies the year the machine was manufactured. For instance, “L” represents 2001, “M” means 2002 and, continuing through the alphabet, “Y” means 2009.
How long should a dryer last?
10-13 years
A dryer should last 10-13 years. To extend the dryer’s life, clean the lint trap after each use and make sure the outer vent is clear as well.
What is the capacity of a Kenmore 90 series dryer?
7.5 cu. ft.
Your Kenmore 90 series dryer is rated at 7.5 cu. ft.
Where is the thermostat located on a Kenmore dryer?
The operating thermostat for your dryer is on the blower housing. It is Key 42 in the first image below. To access this thermostat, unplug the dryer and pull off the back panel. To check it, remove the wires and measure the resistance across the leads of the thermostat with a volt/ohm meter.
