Turn the ignition switch on and wait 3 seconds. Immediately after the 3 seconds, the accelerator pedal must be pressed and released 5 times within 5 seconds. Wait 7 seconds and fully press the accelerator pedal and hold for approximately 20 seconds until the check engine light stops blinking and stays on.
How do you relearn a idle on a 2007 Nissan Altima?
Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. 20 seconds until the MIL stops blinking and turned ON. Fully release the accelerator pedal within 3 seconds after the MIL goes off. Start engine and let it idle.
How do I reset idle relearn?
Simple Idle Learn Procedure
- Pull the handbrake.
- Put the car in neutral or in Park Mode.
- Warm the engine up a bit.
- Let the engine idle for 5 minutes.
- Only then turn the air conditioner on.
- Repeat step 4.
- Put the car in Drive Mode.
- Repeat step 4.
What should a Nissan Altima idle at?
700 rpm in neutral or putting drive is normal or when idling at stops anything above 750 will turn on the check engine lite. Idle must set at dealer called idle volume learning if it gets out of specs and throttle body may have to be replaced.
Why does my Nissan Altima idle?
While there are a variety of reasons your Nissan Altima has a rough idle, the most common 3 are a vacuum leak, an issue with the spark plugs, or a problem with the ignition coil.
How do you reset the computer on a Nissan Altima?
Reset the computer and turn the service engine soon light off by repeating the first process completely, with one exception: When the pedal is lifted after pressing the pedal down for 10 seconds and the codes are flashing, depress the pedal again for an additional 10 seconds and the computer will reset.
How do you reset the idle on a 2003 Nissan Altima?
This procedure can only be done with the SES light off and all codes cleared.
- Drive the car to “warm up” temperature.
- Turn the car ignition key to “OFF”
- Wait ten seconds.
- Turn the key to “ON” (not start)
- Wait three seconds.
- Fully press and release the gas pedal 5 times within five seconds.
How do I fix code P0507?
What repairs can fix the P0507 code?
- Replacing or cleaning the idle air valve.
- Repairing the intake air leak.
- Repairing the charging system.
- Cleaning the throttle body.
- Replacing the power steering pressure switch.
How long does it take for a car computer to reset?
The readiness monitors will remain until the car has been driven long enough for the computer to evaluate the various system and sensors. The amount of time can vary based on the vehicle. In some cases it can take up to 100 miles for all of the computer monitors to completely reset.
What RPM should a Nissan Altima idle at?
How to do a Nissan Altima idle learn?
How to Do a Nissan Altima Idle Relearn. 1 Step 1. Without stepping on the gas pedal, turn the ignition switch to on and wait at least two seconds, then turn the ignition switch off and wait 10 2 Step 2. 3 Step 3. 4 Step 4.
When to perform a Nissan idle relearn procedure?
If you’ve performed a major repair, disconnected the battery, or disconnected a MAF sensor while the engine is running, you may have to perform a Nissan idle relearn procedure (also called an idle air volume relearn procedure).
What should I do if my idle light is solid?
Release the pedal within three seconds after the light becomes solid. Start the engine and let it idle, wait 20 seconds, then rev the engine a few times and make sure the idle returns to normal idle speed. Mike Vasick has more than 25 yrs in the auto repair industry.He is factory-certified for repair on Nissan and Subaru vehicles.
Does the 2003 Nissan Altima have an electronic throttle body?
In 2003 the Nissan Altima came equipped with an electronic throttle body. Whenever you disconnect the battery or replace the computer or throttle body, you must perform a relearn procedure. The process involves some steps with a cold engine and others with a warmed-up engine.
