The saltwater chlorinator needs a sufficient flow of water for effective operation. A dirty skimmer basket, clogged or dirty filter, and a clogged pump strainer, can cause insufficient water flow for the chlorinator to produce less chlorine.
Why is my Hayward chlorinator not working?
The Chlorinator Has an Air Lock An air lock inside the chlorinator can also reduce flow and chlorination. To clear an air lock, remove the lid, then turn on the pump and allow the chlorinator to fill with water. Turn off the pump; replace the lid, and turn the pump back on again.
How do I reset my Hayward chlorinator?
To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.
Do I need a check valve on my chlorinator?
A check valve for a chlorinator is used to prevent chlorine gas from entering into the pool equipment. ALL CHLORINATORS SHOULD HAVE A CHECK VALVE ASSEMBLY. CL220 has a check valve assembly built into the discharge fitting. In addition, the black tubing, on the discharge side should be looped.
How do you clean a Hayward chlorinator?
Hayward Chlorinator Maintenance Do not use any solvents or chemicals to clean, which can cause a reaction. Use only water to flush out the feeder. For Off-Line models, a new Check Valve & Inlet Fitting (CLX220EA) is in order every few years, to keep water flowing properly.
How do you clean a Hayward automatic chlorinator?
How do you reset inspect on Hayward?
If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
What should my Hayward chlorinator be set at?
How much salt does the system require? Salt Systems work best with approximately 3200 parts per million (ppm) of salt, which is roughly the equivalent to a teaspoon of salt per gallon. However, all Hayward Salt Systems are designed to operate with salt levels anywhere from 2700 ppm to 3400 ppm.
Hayward chlorinators can get clogged or they can leak. Both problems can be easily resolved after you remove the lid.
What is the difference between the Hayward cl220 and cl110 chlorinator?
The Hayward CL110 Chlorinator is a bit different from the CL220 model. This model uses flexible black chlorine feeder hoses to connect the tank to the filter system. From time to time these lines will become brittle and need to be replaced. You can buy replacement Hayward Chlorine feeder lines online or from a local swimming pool supply store.
When should you repair or replace your salt chlorinator?
The salt cell will eventually lose performance and the controller circuit boards can develop problems over time. New technology in salt systems may also sway your decision to repair or replace your salt chlorinator. Newer models self-clean and self-diagnose and other advanced features.
How do you replace the lines on a Hayward chlorine feeder?
From time to time these lines will become brittle and need to be replaced. You can buy replacement Hayward Chlorine feeder lines online or from a local swimming pool supply store. To replace the lines on the Hayward CL110 Chlorinator you will need to loosen the nuts at the end of each line.
