safer medical device. What term is used to describe a physical or mechanical device used to remove health hazards from the workplace? engineering control.
What is the term used to describe medical practices that help to keep an object or area clean and free from infection?
Commonly known as clean technique, medical asepsis prevents the transmission of microorganisms from one person or area to any other within the medical office. Follow the guidelines published by OSHA and the CDC to protect yourself and to prevent the transmission of disease.
What term is used to describe a micro organism that does not produce disease?
Nonpathogenic organisms are those that do not cause disease, harm or death to another organism and is usually used to describe bacteria. It describes a property of a bacterium – its ability to cause disease. Most bacteria are nonpathogenic.
What is the term for an infection that results from a defective immune system that Cannot defend itself from pathogens normally found in the environment group of answer choices?
Acquired Immune Deficiency Syndrome (AIDS): A medical condition where the immune system cannot function properly and protect the body from disease. As a result, the body cannot defend itself against infections (like pneumonia). AIDS is caused by the Human Immunodeficiency Virus (HIV).
What is the most effective work practice control measure?
What is the most effective work practice control measure? It is generally depicted as a pyramid with the most effective method — engineering controls — at the pinnacle, followed by administrative/work practice controls, and finally the least effective — personal protective equipment (PPE).
What is the most effective infection control procedure?
Hand hygiene is considered one of the most important infection control measures for reducing the spread of infection. Hand hygiene is a general term that refers to any action of hand cleansing, such as handwashing or handrubbing.
What are the 2 types of asepsis?
There are two types of asepsis – medical and surgical. Medical or clean asepsis reduces the number of organisms and prevents their spread; surgical or sterile asepsis includes procedures to eliminate micro-organisms from an area and is practiced by surgical technologists and nurses.
What are the 7 types of pathogens?
Different types of pathogens
- Bacteria. Bacteria are microscopic pathogens that reproduce rapidly after entering the body.
- Viruses. Smaller than bacteria, a virus invades a host cell.
- Fungi. There are thousands of species of fungi, some of which cause disease in humans.
- Protists.
- Parasitic worms.
What are the 4 types of pathogens?
Pathogen types. There are different types of pathogens, but we’re going to focus on the four most common types: viruses, bacteria, fungi, and parasites.
What should be done to prevent mechanical hazards?
In order to properly protect workers, safeguards should do the following: Prevent contact – prevent worker’s body or clothing from contacting hazardous moving parts Protect from falling objects – ensure that no objects can fall into moving parts Create no new hazards – must not have shear points, jagged edges or unfinished surfaces
How are machine safety devices used in the workplace?
Machine Safety Devices. Safety devices don’t use physical barriers, instead protecting workers by either stopping a machine or restricting machine operators’ movements if they get too close to a hazardous area. They tend to be employed in situations where adjustable, or self-adjusting guards might get in the way.
How are hazard controls used in the workplace?
For example, in the case of a noise hazard, temporary measures might require workers to use hearing protection. Long term, permanent controls might use engineering methods to remove or isolate the noise source. Why should a workplace implement hazard controls? Some hazards and their controls will be specifically outlined in legislation.
Which is a hazardous part of a machine?
Part of the machinery that could be hazardous to workers include sharp edges, hot surfaces, moving parts, flywheel, pulley, belt, etc. It occurs majorly in three (3) area: The point of operation: Point where work is performed on the material, such as cutting, shaping, boring, etc
