How do you use a microscope step by step?

Steps on How to Use a Light Microscope

1. Step 1: Connect the light microscope to a power source.
2. Step 2: Turn the revolving nosepiece so the lowest objective lens is in position.
3. Step 3: Mount your specimen onto the stage.
4. Step 4: Use the metal clips to keep your slide in place.

What are the basic points to remember on how do you use a microscope?

NOTES:

1. Do not touch the glass part of the lenses with your fingers. Use only special lens paper to clean the lenses.
2. Always keep your microscope covered when not in use.
3. Always carry a microscope with both hands. Grasp the arm with one hand and place the other hand under the base for support.

What are the 10 steps in using microscope?

How To Use Your First Microscope

1. Step 1: Moving Your Microscope. Carry the microscope with two hands.
2. Step 2: Microscope Lens Care. Never touch any lens with your fingers.
3. Step 3: Microscope Parts.
4. Step 4: Prepare a Slide.
5. Step 5: Insert the Slide.
6. Step 6: Set Up for Viewing.
7. Step 7: Light Control.
8. Step 8: Focus the Microscope.

What are the basic microscope techniques and rules to follow?

Important general rules: Always carry the microscope with 2 hands—place one hand on the microscope arm and the other hand under the microscope base. Do not touch the objective lenses (i.e. the tips of the objectives). Keep the objectives in the scan position and keep the stage low when adding or removing slides.

What are the three rules in carrying the microscope?

NOTES:

• Do not touch the glass part of the lenses with your fingers. Use only special lens paper to clean the lenses.
• Always keep your microscope covered when not in use.
• Always carry a microscope with both hands. Grasp the arm with one hand and place the other hand under the base for support.

What techniques do you use to properly place a sample in a microscope?

The main methods of placing samples onto microscope slides are wet mount, dry mount, smear, squash and staining. Dry Mount: The dry mount is the most basic technique: simply position a thinly sliced section on the center of the slide and place a cover slip over the sample.